|
|
|
|
C - JET PUMP DO's AND DON'Ts |
| Don't |
Run pump dry (without water). |
| Do | Fill pump and plumbing with water before startup. |
| Do | Make certain all valves and nozzles on both the inlet and outlet side of the pump are open while the pump is in operation. |
| Do | Install pressure relief valve. |
| Don't | Pump water which contains sand, mud, silt, or debris. |
| Don't | Pump oil, petroleum products, chemicals, cleaning agents or viscous liquids |
| Do | Ground motor, do not ground to gas supply line. |
| Do | Wire motor to correct supply voltage - see motor nameplate and wiring diagrams and check voltage of power supply. |
|